After a number of tries I've spotted that my boot logs are pretty same for different images (lubuntu and android). And I found a problem - as noticed in many places on forum - it is an SD card! The big confusion was that SD card silently ignores any write operations, so dd utility works fine without...

Okay, about the boot, I see the gist here... :roll: As seen in the wiki, in the Make an Installation SD Card / Boot NanoPi Fire3 from SD Card section : Insert this card into your NanoPi Fire3's boot slot(1), press and hold the boot key(2) and power on (with a 5V/2A power source). If the PWR LED is ...

I'm agree with asmodyne.. Is where some next steps? As you notices above I've buy a debug port board and show you all logs you wanted. But what should I do next? May be anyone have logs of fully functional system booting to compare its with my one and to try to find a problem by myself? UPD. Just in...

3. With X710 display and power button holded scratch is broken, clear watchdog timer start working to aarch32 waiting for pll change.. -------------------------------------------------------------------------------- Second Boot by Nexell Co. : Ver0.3.6 - Built on Jun 29 2016 15:19:53 ---------------...

2. Without display at all (HDMI mode) scratch is broken, clear watchdog timer start working to aarch32 waiting for pll change.. -------------------------------------------------------------------------------- Second Boot by Nexell Co. : Ver0.3.6 - Built on Jun 29 2016 15:19:53 ----------------------...

1. With X710 display connected, normal mode (no pwer button holded) scratch is broken, clear watchdog timer start working to aarch32 waiting for pll change.. -------------------------------------------------------------------------------- Second Boot by Nexell Co. : Ver0.3.6 - Built on Jun 29 2016 1...

Well, now I have MAX3232 and I'm able to log debug port. Here is my three boot logs: 1. With X710 display connected, normal mode (no pwer button holded) 2. Without display at all (HDMI mode) 3. With X710 display and power button holded Output is splitted into three separate messages due to one messa...

Hi. I can't boot my fire3 board. I've attached two videos (with power button holded on and off) - same results for any image (core-qte, lubuntu and android) downloaded from official site. I've linux on my host machine and I've tried both methods of creating installation SD card - from image and via ...