here are also the usb-devices output of the Odroid XU4 T: Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 2 Spd=480 MxCh= 0 D: Ver= 2.00 Cls=00(>ifc ) Sub=00 Prot=ff MxPS=64 #Cfgs= 3 P: Vendor=12d1 ProdID=15c1 Rev=01.02 S: Manufacturer=Huawei Technologies Co., Ltd. S: Product=HUAWEI Mobile V7R11 S: Seria...

hy I use a me909s-120 Modem on a Odroid Xu4 machine which works fine. On the Odroid as soon as I plug the Modem into the USB 5 new USB devices are recognized. However when I do the same on my Neo Core 2 no USB devices are installed. Here is the output of de dmesg after plugin the USB Modem: [ 349.59...

Hy I used the xxxeflasher.img file for my Core 2 and used diskimager to put it onto a 16GB card. Now in the wiki its written that when I plug into a PC I should see a FAT drive where all the OS are stored and additional OS can be copied. However I only see the "boot" partition the others a...

Thx didn't know the FEL mode seems a great way to save the image to the eMMC

Andy

Thx a lot for the infos! Great! I still try to figure out what the best solution is to bring my custom OS that is currently running on a Core 2 to all the other Core 2 units. Currently I copy the whole Partition with the dd command to the SD-Card and then copy it back on the other Core 2 with a boot...

ok so the standard U-Boot delivered with the Core 2 has no USB support.

So how can I get a "new" u-boot that is compatible with the Core 2?

Andy

Here is the whole terminal output: CPU: Allwinner H5 (SUN50I) Model: FriendlyElec NanoPi H5 DRAM: 1 GiB Sy8106a: 1200mv CPU Freq: 1008MHz MMC: SUNXI SD/MMC: 1, SUNXI SD/MMC: 0 *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Net: No ethernet found. SID: 82800001-44...

push

I have the same problem.
When I lauch the command I get this error back:


Andy

Hy I tried to run clonezilla from a usb stick so i can clone the eMMC to the USB stick. However it does not boot from the stick. When I view this over the DEBUG Serial prot I see: starting USB... No controllers found And then it boots form the eMMC ... What can I do to start it from the USB? Andy

Hy

I have a Core2 running ubuntu on the eMMC.
Now I like to make a full copy of the eMMC so I can distribute the system onto other Core2 boards

Can someone help me how to to this the most efficient way?
(gparted, dd, clonezilla ..?)

Andy

Hy

I have a Mini Shield for NanoPi with a NEO Core2. Now the shield has an m.2 SATA port.
Is it possible to run a m.2 4G Modem over this port?

Andy