Is it possible to modify the NAS Dock, what would the power off button send the signal to the system for shutdown?

I received a NAS Dock 1.2 and NanoPi Neo2 with a soldered pins header, HDD connected to SATA works well.

Has anyone re-soldered NanoPi header pins? Are there any success?

My header pins are not soldered, but initial testing seems to indicate the new board now recognizes the internal drive. Need to follow up with OMV to see if I can get it set up and running properly. Please tell us here if you can get the OMV to work with hard disk via NAS. I had initially bolted it...

Hi， There is a possibility under this circumstances is that the connection pin on the NEO/NEO2 board is having an insecure soldering so the USB device is not detected. The NAS was checked before out of the factory. Could you guys solder the CPU board Pins again then test the nas dock again? thank y...

Hi， There is a possibility under this circumstances is that the connection pin on the NEO/NEO2 board is having an insecure soldering so the USB device is not detected. The NAS was checked before out of the factory. Could you guys solder the CPU board Pins again then test the nas dock again? thank y...

Mindee, with which HDD and SSD models did you test version 1.2?

Which version of NAS Dock do you have problems with? Did you try another image of the operating system, for example armbian?