Page 1 of 1
how to use matrix with nanopi2
Posted: Tue Dec 01, 2015 1:32 pm
by rymtek
follow the steps described at webpage
http://wiki.friendlyarm.com/wiki/index. ... x_-_ButtonI have compiled the code,but I can't find /dev/sensor,I think I need gpio driver,where can find the driver?
Re: how to use matrix with nanopi2
Posted: Wed Dec 02, 2015 9:44 am
by FATechsupport
Hi
We simplied the code and the compiling process. We are updating our wiki for this section. Please check our wiki in two days.
Re: how to use matrix with nanopi2
Posted: Wed Dec 02, 2015 10:38 am
by FATechsupport
Hi we already updated the wiki. Please check the "Connect to NanoPi 2" section in the following link.
http://wiki.friendlyarm.com/wiki/index. ... x_-_Button
Re: how to use matrix with nanopi2
Posted: Fri Jan 15, 2016 4:38 am
by argentolee
May I know Ubuntu14.04 that is use to compile a 32-bit or a 64-bit version?
Please also provide the detail of the package name of arm-linux-gcc-4.9.3 when installing from apt-get install.
Thank you.
Re: how to use matrix with nanopi2
Posted: Fri Jan 15, 2016 4:41 am
by argentolee
May I know if the Ubuntu in use 32 or 64 bit?
Also please provide the package name for arm-linux-gcc-4.9.3 when installing through software center.
Thank you.
Re: how to use matrix with nanopi2
Posted: Mon Jan 18, 2016 6:13 am
by FATechsupport
argentolee wrote:
May I know if the Ubuntu in use 32 or 64 bit?
Also please provide the package name for arm-linux-gcc-4.9.3 when installing through software center.
Thank you.
It is Ubuntu 14.04 64 bit system.
The compiler is "arm-cortexa9-linux-gnueabihf-4.9.3.tar.xz"
All these details can be found on our wiki:
http://wiki.friendlyarm.com/wiki/index.php/NanoPi_2