5inch LCD Display W500 - touch error

: miw0909

: Posts: 1; Joined: Tue Nov 19, 2019 1:01 am

Tue Nov 19, 2019 2:39 am

by miw0909 » Tue Nov 19, 2019 2:39 am

When we touch an LCD, it will stop with the following message on Smart4418. (4.4.172-s5p4418 version is in use.)

nexell-i2c c00a6000.i2c: trans[ 0: 3]
nexell-i2c c00a6000.i2c: Fail, arbit i2c.2 addr [0x28] data[0x28],
nexell-i2c c00a6000.i2c: trans[ 0: 3]
nexell-i2c c00a6000.i2c: Fail, arbit i2c.2 addr [0x28] data[0x28],
nexell-i2c c00a6000.i2c: trans[ 0: 3]

Is there a solution?

Re: 5inch LCD Display W500 - touch error

: v8dave

: Posts: 383; Joined: Thu Apr 06, 2017 12:57 am; Location: Jakarta, Indonesia

Tue Nov 19, 2019 9:12 am

by v8dave » Tue Nov 19, 2019 9:12 am

miw0909 wrote:
nexell-i2c c00a6000.i2c: trans[ 0: 3]
nexell-i2c c00a6000.i2c: Fail, arbit i2c.2 addr [0x28] data[0x28],

Do you have any other device on the I2C bus that is using the same address?

Are you able to check the I2C to see if there is clock and data appearing?

Very funny Scotty, now beam down my clothes.

Who is online

In total there are 3 users online :: 0 registered, 0 hidden and 3 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 3 guests