Power & Source of Big Ideas

Nano PI M2 won't start

Moderators: chensy, FATechsupport

Seeing that no one answer the question I posted on bootloader section, I decide to post the same question on all the sections about Nano PI M2 with Samsung S5P4418.
With ALL images availables (Friendlycore, Frienflywrt, Android and Ubuntu) the board don't boot: stops during uboot with the following message (taken from the UART console):

BL1 by Nexell V1.0.0-gd551e13 [Built on 2018-01-25 16:58:29]

Memory Initialize (0) Done.

Loading from sdmmc...
Image Loading Done!
Launch to 0xB0FE0400


U-Boot 2016.01-00041-ga7bea11237 (Nov 08 2019 - 16:56:31 +0800)

Model: FriendlyElec boards based on Nexell s5p4418
Board: s5p4418-X
DRAM: 1020 MiB
Panel: N/A (-1)
MMC: NEXELL DWMMC: 0, NEXELL DWMMC: 1
HDMI: display.0, preset 0 (1280 * 720)
HDMI: phy ready...
LCD: [HDMI] dp.0.1 1280x720 32bpp FB:0x77000000
In: serial
Out: serial
Err: serial

Hit any key to stop autoboot: 0
6165728 bytes read in 430 ms (13.7 MiB/s)
5880768 bytes read in 400 ms (14 MiB/s)
** File not found s5p4418-nanopi2-rev05.dtb **
libfdt fdt_check_header(): FDT_ERR_BADMAGIC
Kernel image @ 0x71080000 [ 0x000000 - 0x5e14e0 ]
ERROR: Did not find a cmdline Flattened Device Tree
Could not find a valid device tree
nanopi2#
No one still helped me, anyway I've discovered two things:
- today I've received a new Nano PI M2A: images from download page works like a charm;
- images from download page of Nano PI M2A and Nano PI M2 are exactly the same.
I know that this two SoCs are very similar, but only in dimension and layout: the circuitry has lot of differences so the image could not be the same: could be that there has been a link error in pointing the right download page of Nano PI M2 images?
Please help me: I've bought more than one Nano PI M2 and I would like to use them!

Who is online

In total there are 5 users online :: 0 registered, 0 hidden and 5 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 5 guests