Order it on 8/15/2016 and got it today 9/2/2016. This time order it with a 3 amp 5 volt power supply and the case and heat sink. The case comes with the 4 screws. But one of mine the Philips head is messed up and I can't get a hold of it to screw it in. So only used 4 of the screws. Any one know were can buy them same type of screws? I just need one. They seem hard to find.
Putting a image on a 8GB SD card now as I type this. I guess it will work good just like my last one. I hope it get's a DHCP address. My other one did not seem like it did. I hooked a RS232 on it to see what it was.
All ready got the case and heat sink on this one.
Thank you for this NanoPi NEO it's very small and runs very good.
-Raymond Day
Putting a image on a 8GB SD card now as I type this. I guess it will work good just like my last one. I hope it get's a DHCP address. My other one did not seem like it did. I hooked a RS232 on it to see what it was.
All ready got the case and heat sink on this one.
Thank you for this NanoPi NEO it's very small and runs very good.
-Raymond Day