Hello! Linux veteran, but new to this SBC stuff.
I'm having trouble setting up my NanoPi R1.
I followed instructions from http://wiki.friendlyarm.com/wiki/index.php/NanoPi_R1
Stuck at this step: 4.3.1.1 Flash to eMMC
I plugged in my NanoPi to my computer, powered it up.
It gets an IP address but I can't connect to SSH.
I did nmap on it and only port 8200 is open.
I tried:
-to login to ssh many ways: ssh root@[IP address] / ssh root@ [ip address] -p 8200
-tried plugging it into WAN ethernet port, it can't get IP
-tried connecting to FriendlyElec wifi network that appeared.
Is my NanoPi R1 broken? It's weird that it's so hard to connect to it. What is port 8200 for?
I'm having trouble setting up my NanoPi R1.
I followed instructions from http://wiki.friendlyarm.com/wiki/index.php/NanoPi_R1
Stuck at this step: 4.3.1.1 Flash to eMMC
If your board doesn't support HDMI or no monitor is connected you can select an OS by running the following command:
$ su root
$ eflasher
I plugged in my NanoPi to my computer, powered it up.
It gets an IP address but I can't connect to SSH.
I did nmap on it and only port 8200 is open.
I tried:
-to login to ssh many ways: ssh root@[IP address] / ssh root@ [ip address] -p 8200
-tried plugging it into WAN ethernet port, it can't get IP
-tried connecting to FriendlyElec wifi network that appeared.
Is my NanoPi R1 broken? It's weird that it's so hard to connect to it. What is port 8200 for?