Hello,
I was playing around with network settings trying to make armbian a router, but now I can't login via SSH.
armbian is installed to eMMC
how to reset? or reflash eMMC? or boot off of SD card?
1. I tried flashing SD card with nanopi-r1_eflasher_friendlywrt_4.14_armhf, doesn't seem to boot from that
2. held reset button a long time, doesn't seem to do anything
tips?
i was trying to run before, walking.
I was playing around with network settings trying to make armbian a router, but now I can't login via SSH.
armbian is installed to eMMC
Code: Select all
$ sudo arp-scan 192.168.0.1-192.168.3.1
[sudo] password for admin:
WARNING: Could not obtain IP address for interface enp3s0. Using 0.0.0.0 for
the source address, which is probably not what you want.
Either configure enp3s0 with an IP address, or manually specify the address
with the --arpspa option.
Interface: enp3s0, datalink type: EN10MB (Ethernet)
Starting arp-scan 1.9.5 with 769 hosts (https://github.com/royhills/arp-scan)
192.168.0.14 12:81:3b:15:76:9c (Unknown)
192.168.2.1 12:81:3b:15:76:9c (Unknown)
192.168.2.20 12:81:3b:15:76:9c (Unknown)
ssh admin@192.168.0.14
ssh: connect to host 192.168.0.14 port 22: Network is unreachable
how to reset? or reflash eMMC? or boot off of SD card?
1. I tried flashing SD card with nanopi-r1_eflasher_friendlywrt_4.14_armhf, doesn't seem to boot from that
2. held reset button a long time, doesn't seem to do anything
tips?
i was trying to run before, walking.