Power & Source of Big Ideas

NanoPC-T2 does not get IP after boot on ubuntu

Moderators: chensy, FATechsupport

I have nanopc-T2, It does not get IP with Ethernet when I connect it to my host(PC with DHCP IP). I install ubuntu with qt core, this is wiki page said for Ip:"If a board is connected to a network via Ethernet before it is powered on it will automatically obtain an IP with DHCP activated after it is powered up." I do that but again write on LCD : IP:0.0.0.0
how can I solve it?
leemccarthyn wrote:
I have nanopc-T2, It does not get IP with Ethernet when I connect it to my host(PC with DHCP IP). I install ubuntu with qt core, this is wiki page said for Ip: "If a board is connected to a network via Ethernet before it is powered on it will automatically obtain an IP with DHCP activated after it is powered up." I do that but again write on LCD : IP:0.0.0.0
how can I solve it?

Those images and upgrades were tested many many times, because support is expensive and "you" forget to cover that cost. I test this particular case 3x:

- updating installation which was already on eMMC

- one old version: Armbian_5.75_Nanopct4_Debian_stretch_default_4.4.174.7z

- the same as you did: Armbian_5.91_Nanopct4_Debian_buster_default_4.4.179.7z http://ix.io/1TCV

... and I can't reproduce. How can we explain this case?



Have you read this: https://docs.armbian.com/User-Guide_Getting-Started/?



Do you use decent/quality SD card?
Proper SD card writing method?

Official PSU?

I think this armbian quoted message will help you to understand this thing.

Who is online

In total there are 4 users online :: 0 registered, 0 hidden and 4 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 4 guests