Can't get wlan stick up and running as it should

[Kyruss]

Hello,

if I use the command ifconfig, with the plugged wlan stick not as wlan0, but is displayed as wlxe84e06454862.
It is a EDUP Stick with a RTL8192CU Chipset.

If i run:

sudo nmcli dev
DEVICE TYPE STATE CONNECTION
eth0 ethernet connected Wired connection 1
wlxe84e06454862 wifi connected MyWLan
lo loopback unmanaged --


The Config was done with sudo nmcli dev wifi connect "SSID" password "PASSWORD".

But I'can get the Adapter to be wlan0, and to be configured with a static address.

Any help is welcome.

cu
Matthias

[guidol]

if I use the command ifconfig, with the plugged wlan stick not as wlan0, but is displayed as wlxe84e06454862.
It is a EDUP Stick with a RTL8192CU Chipset.

wlxe84e06454862 wifi connected MyWLan

The Config was done with sudo nmcli dev wifi connect "SSID" password "PASSWORD".
But I'can get the Adapter to be wlan0, and to be configured with a static address.

It hasnt to be wlan0. wlxe84e06454862 is done after the new naming convention in debian 9 stretch.

For getting a static IP for this device name take a look at the following FAQ-Page:
http://wiki.friendlyarm.com/wiki/index. ... _Static_IP

or try to change the device-entry with the console-gui version of nmcli which is named nmtui