Power & Source of Big Ideas

how can i radio frequency testing with nanopi-r1?

Moderators: chensy, FATechsupport

Hello.

I have a question about nanopi-r1
want to make its WIFI to transmit continuously (RF test) to meet the lab testing requirements
I cannot find any document about that

have any software package that supports lab testing(radio frequency testing)?
If not, is there any other way can help for lab testing on AP6212 hardware?

Thank you for your help.
If you just want to see how much RF interference. Just put a old AM radio next to it. Can hear a lot of interference then.

You can make a radio wave by just touching 2 wires together. AM is adjusting the power of the spark FM is how fast you do the spark in megahertz.

-Raymond Day
The best solution for RF testing is with a spectrum analyser and come RF probes. They are cheap now compared to a few years ago.

Who is online

In total there are 6 users online :: 0 registered, 0 hidden and 6 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 6 guests