Power & Source of Big Ideas

Add 3.7v Battery Power+Charging, Power via USB-OTG to NanoPi

Moderators: chensy, FATechsupport

Your products are very interesting to us, but we cannot consider using them for our products because none of your products offer support for 3.7v Lithium battery charging and power, and ability to charge and power over a USB OTG port.

[url=https://bananapi.gitbooks.io/bpi-m2-ultra-open-source-single-board-computer/content/bpi-m2ultra37vlithiumbatteryinterface.html
]Banana Pi M2 Ultra has these features[/url], but it is very hard to get them to answer questions about their products. We cannot even get them to provide a model number for the non-standard battery connector they use (at least not yet.) So we am afraid to depend on them.

Note: We would be happy to spend twice (2x) as much or more for your products if they supported battery power and charging.
Hi,
We suggest you use a 5V power,but if you want to use 3.7v power you must use it carefuly. Or you can refer friendlyelec's 8x1.5V Battery Holder with Standard Snap Connector: http://www.friendlyarm.com/index.php?ro ... uct_id=157

Who is online

In total there are 44 users online :: 0 registered, 0 hidden and 44 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 44 guests