FriendlyELEC-Forum

Hi All,

Is there anyone who did get the Razberry GPIO working on the NanoPI Neo Plus2 Hardware?

On the raspberry pi I did use the /dev/ttyAMA0, but in the NanoPI this isn't available, also none of the LED lights will light up.

On the raspberry Pi 3 you should disable bluetooth but I don't have know idea of too do this on the NanoPI.

WiringNP, it same as WiringPi

You can find a procedure to power on/off/reset the bluetooth from GPIO at this page https://github.com/lcrb/meta-omega

I finally got it.. I configured the wrong serialport during the installation of the razberry hardware.