NanoPi K1 Plus eMMC boot
Posted: Wed Feb 27, 2019 6:51 pm
Hi, I bought NanoPi K1 plus and I am trying to make it boot from emmc which I bought from FE, too. I tried both Android and eflasher and failed. Problem is, FE didn’t explain good enough. There are some misleading lines of text on FE wiki page.
Android:
They said that I have to “insert a TF card(at least 8G)” in my pc and start “flashing the Android image to eMMC”. If I insert TF card, how can I flash emmc? After that they said that I have to insert TF card to a Nano pi and boot up the board, After that, to power it down, take out TF card and boot it again. This time from emmc.
What to burn to TF? What to burn to emmc? Do I have to burn Android image on both? What to set on Phoenix tool for TF, and what for emmc? To select Product on both burning processes? Or some have to be Product and some have to be Startup?
Linux:
They said to burn image file to TF. Which one? There are two in .tgz file I downloaded from FE drive, boot and rootfs. What to do with emmc? Should I burn something on it or just to insert it on board? If I need to burn something, then what?
As you can see, bunch of crossroads. If someone made to boot this board from eMMC, please, explain me how.
Thank you in advance.
Android:
They said that I have to “insert a TF card(at least 8G)” in my pc and start “flashing the Android image to eMMC”. If I insert TF card, how can I flash emmc? After that they said that I have to insert TF card to a Nano pi and boot up the board, After that, to power it down, take out TF card and boot it again. This time from emmc.
What to burn to TF? What to burn to emmc? Do I have to burn Android image on both? What to set on Phoenix tool for TF, and what for emmc? To select Product on both burning processes? Or some have to be Product and some have to be Startup?
Linux:
They said to burn image file to TF. Which one? There are two in .tgz file I downloaded from FE drive, boot and rootfs. What to do with emmc? Should I burn something on it or just to insert it on board? If I need to burn something, then what?
As you can see, bunch of crossroads. If someone made to boot this board from eMMC, please, explain me how.
Thank you in advance.