Page 1 of 1
Bricked pik2
Posted: Wed May 16, 2018 2:44 am
by hough
My pi k2 will no longer boot any images. I plugged
It into my pc via usb and it is recognized as a device. Is there a way to unbrick my unit?
Re: Bricked pik2
Posted: Wed May 16, 2018 7:31 pm
by davef
Has it got a UART port that you can plug something like the PSU-ONECOM into and look at the boot messages?
Re: Bricked pik2
Posted: Thu May 17, 2018 12:47 pm
by guidol
hough wrote:
My pi k2 will no longer boot any images. I plugged
It into my pc via usb and it is recognized as a device. Is there a way to unbrick my unit?
Did you try another card or to write the images with the software "Etcher"?
update 5/25 Bricked pik2
Posted: Fri May 25, 2018 4:09 pm
by hough
Allcon,
Just an update, unfortunately i do not think it will help many people. My Pik2 was not bricked,, it just had no display. I could access it from the network SSH. After putting it on a scope i found D4 sod-303 was missing. turns out its pretty important. I must have broken it off when i was playing catch in the yard with my pops. I replaced it aand have it back up and running.
Thanks for the help.