Page 1 of 1
Bricked pik2
Posted: Wed May 16, 2018 2:44 am
by hough
My pi k2 will no longer boot any images. I plugged
It into my pc via usb and it is recognized as a device. Is there a way to unbrick my unit?
Re: Bricked pik2
Posted: Wed May 16, 2018 7:31 pm
by davef
Has it got a UART port that you can plug something like the PSU-ONECOM into and look at the boot messages?
Re: Bricked pik2
Posted: Thu May 17, 2018 12:47 pm
by guidol
hough wrote:
My pi k2 will no longer boot any images. I plugged
It into my pc via usb and it is recognized as a device. Is there a way to unbrick my unit?
Did you try another card or to write the images with the software "Etcher"?
update 5/25 Bricked pik2
Posted: Fri May 25, 2018 4:09 pm
by hough
Allcon,
Just an update, unfortunately i do not think it will help many people. My Pik2 was not bricked,, it just had no display. I could access it from the network SSH. After putting it on a scope i found D4 sod-303 was missing. turns out its pretty important. I must have broken it off when i was playing catch in the yard with my pops. I replaced it aand have it back up and running.
Thanks for the help.
Re: update 5/25 Bricked pik2
Posted: Mon Jan 20, 2025 9:03 am
by missdomenica
hough wrote:
Allcon,
Just an update, unfortunately i do not think it will help many people. My Pik2 was not bricked,, it just had no display. I could access it from the network SSH. After putting it on a scope i found D4 sod-303 was missing. turns out its pretty important. I must have broken it off when i was playing catch in the yard with my pops. I replaced it aand have it back up and running.
Thanks for the help.
You have to follow the publisher to see if they release a new version to update it to the latest version, which will have many support features as well as fewer errors compared to the previous version. Anyway, congratulations to that person for successfully finding and fixing the error.