Thu Jul 11, 2019 10:46 am
Can't find info on this in the wiki - which jumper position does what? Thanks.
Power On Mode Select Jumper
Moderators: chensy, FATechsupport
Tue Jul 16, 2019 7:15 am
Looks like it comes from factory set to boot on return of power after a cut...
Tue Jul 16, 2019 10:32 am
crsp wrote:
Looks like it comes from factory set to boot on return of power after a cut...
Yip. My T4 boots on applying power so looks like FA set this as the default on later boards. For boards without this, the following needs to be done.
Only need to solder in 2 parts, resistor and capacitor.
http://wiki.friendlyarm.com/wiki/index. ... y_T4_PWRON
Who is online
In total there are 74 users online :: 0 registered, 0 hidden and 74 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm
Users browsing this forum: No registered users and 74 guests
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm
Users browsing this forum: No registered users and 74 guests