Hi All,
I have just bought a nanoPiM4-V2 board.
I followed the instruction from its Wiki page how to prepare mSD card for use it.
I created a mSD card wth the "rk3399-sd-lubuntu-desktop-xenial-4.4-armhf-20201027" image.
I inserted into the slot, everything was fine the Pi booted up.
After approx. 20 seconds of the boot the board was frozen.
I disconnected the power cable. Waited few seconds and tried to reconnect it.
But from this moment nothing happend. Absolutely nothing. If I connect the power cable only the red LED blink quickly (not light!) nothing else happens - no boot, the green LED doest not light or blink.
I have cheked in my laptop the content of the mSD card - as is needed.
Does somebody have any idea or suggestion what do I have to boot again my board?
Thank you in advance,
SziroG
PS: Of course the power adapter - Samsung one, but I have got an UGREEN too - can provide 5V / 3A.
I have just bought a nanoPiM4-V2 board.
I followed the instruction from its Wiki page how to prepare mSD card for use it.
I created a mSD card wth the "rk3399-sd-lubuntu-desktop-xenial-4.4-armhf-20201027" image.
I inserted into the slot, everything was fine the Pi booted up.
After approx. 20 seconds of the boot the board was frozen.
I disconnected the power cable. Waited few seconds and tried to reconnect it.
But from this moment nothing happend. Absolutely nothing. If I connect the power cable only the red LED blink quickly (not light!) nothing else happens - no boot, the green LED doest not light or blink.
I have cheked in my laptop the content of the mSD card - as is needed.
Does somebody have any idea or suggestion what do I have to boot again my board?
Thank you in advance,
SziroG
PS: Of course the power adapter - Samsung one, but I have got an UGREEN too - can provide 5V / 3A.