New install on a clean build
On boot shows the green & blue FriendlyElec GUI splash & smiley face, then briefly below it in grey "Powered by RK3399"
LED's rotate Red5 secs, Green 2 flashes.
Continuous loop.
Can I access anything before the splash, to pause it or see console?
Recommended debug actions? Serial console? Inspect /var/log on root fs on SD card? Any other magic keysequences? Firmware update?
Is this expected on new installs?
- * Nano Pi M4 v2 4Gb, new out of the box
- * rk3399-eflasher-friendlydesktop-bionic-4.4-arm64-20200916 image on 8Gb Micro SD
- * No hats. Only peripheral is USB keyboard. Ethernet connected. USB-C power. HDMI screen.
On boot shows the green & blue FriendlyElec GUI splash & smiley face, then briefly below it in grey "Powered by RK3399"
LED's rotate Red5 secs, Green 2 flashes.
Continuous loop.
Can I access anything before the splash, to pause it or see console?
Recommended debug actions? Serial console? Inspect /var/log on root fs on SD card? Any other magic keysequences? Firmware update?
Is this expected on new installs?