Power & Source of Big Ideas

android does not boot after adding services to aosp-nanopim4

Moderators: chensy, FATechsupport

Hi ,

My experience with the nano-pi m4 board with Android was a success story after following the guide here http://wiki.friendlyarm.com/wiki/index. ... ource_Code,

I wanted to customize the hal driver driver with android service part failed ,i followed the tutorial here https://blog.csdn.net/yong_xu/article/details/80911535 ,
i have got AOSP compiled successfully ,but the image booting to blank pink screen ,
the red light on dev board is on static ,green led is blinking ,

My second question is that how do enable debug port ,uart4 in android aosp build ,is there any special config
booting issue was with JNI layer ,corrected the code its working .
Debug port it already mentioned here http://wiki.friendlyarm.com/wiki/index. ... ble_Boards ,

UART4 available for users and its device name is "/dev/ttyS4" (Note: it is only available in ROMs generated on June 18,2018 or after)

hope it helps

Who is online

In total there are 4 users online :: 0 registered, 0 hidden and 4 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 4 guests