I am getting an error trying to get the NEO3-LTS and I2C LCD1602 to work. After successfully getting the I2C LCD1602 connected to the NEO3-LTS and following the instructions posted at https://wiki.friendlyelec.com/wiki/inde ... 2C_LCD1602.
$ sudo apt-get update && sudo apt-get install git
$ sudo git clone https://github.com/friendlyarm/matrix.git
$ cd matrix
$ sudo make && sudo make install
I am getting an error when running the command: $ matrix-lcd1602
Hardware:NANOPI-R2
Revision:0002
BoardType:-1
FAHW-Lib: Fail to initPinGPIO
FAHW-Lib: Fail to initPwmGPIO
Fail to init board
So, I decided to follow the instructions for matrix-adruino, but I got an error also:
$ sudo git clone git://github.com/friendlyarm/matrix-arduino.git
fatal: unable to connect to github.com:
github.com[0: 140.82.112.3]: errno=Connection timed out
It seems matrix-arduino.git is not available on github.com
Any assistance would be grateful. I am working on a massive project that could involve purchasing 100 or more of the NEO3 and I2C LCD1602, but I have to make sure I can display the IP address of the NEO3 once it is powered on. We are selecting the NEO3-LTS mainly because of the two available USB headers on the board to connect to other devices; therefore, we cannot use the LCD2USB instead of the I2C LCD1602.
Thank you
$ sudo apt-get update && sudo apt-get install git
$ sudo git clone https://github.com/friendlyarm/matrix.git
$ cd matrix
$ sudo make && sudo make install
I am getting an error when running the command: $ matrix-lcd1602
Hardware:NANOPI-R2
Revision:0002
BoardType:-1
FAHW-Lib: Fail to initPinGPIO
FAHW-Lib: Fail to initPwmGPIO
Fail to init board
So, I decided to follow the instructions for matrix-adruino, but I got an error also:
$ sudo git clone git://github.com/friendlyarm/matrix-arduino.git
fatal: unable to connect to github.com:
github.com[0: 140.82.112.3]: errno=Connection timed out
It seems matrix-arduino.git is not available on github.com
Any assistance would be grateful. I am working on a massive project that could involve purchasing 100 or more of the NEO3 and I2C LCD1602, but I have to make sure I can display the IP address of the NEO3 once it is powered on. We are selecting the NEO3-LTS mainly because of the two available USB headers on the board to connect to other devices; therefore, we cannot use the LCD2USB instead of the I2C LCD1602.
Thank you