Power & Source of Big Ideas

Debug UART FYI

Moderators: chensy, FATechsupport

The debug UART is set at 1500000 (not a typo)
HW and SW flow controls off
chaton78 wrote:
The debug UART is set at 1500000 (not a typo)
HW and SW flow controls off


Is there any way to change this, either through re-compile or run-time?
You can change it by modifying the DTS file. and recompile the OS again.

Who is online

In total there are 3 users online :: 0 registered, 0 hidden and 3 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 3 guests