Power & Source of Big Ideas

R5C GPIO

Moderators: chensy, FATechsupport

Hello,
I have a project that the R5C seems to fit perfectly, except that I need to have a couple of IOs. Specifically I need 2 outputs and 2 inputs.

Does anybody know if there are some spare GPIOs on the board that I could use?

Thank you very much for your time.

Regards,
Triantafillos Paradas
From the doc here :
https://wiki.friendlyelec.com/wiki/inde ... _package_2
The GPIOs are presently used for three UART. Who will use this ? You can disable UART and reuse the GPIO for your needs.
Note I have not tested this so I cannot guide you.

Who is online

In total there are 2 users online :: 0 registered, 0 hidden and 2 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 2 guests